FUEL/GAS DUAL TANK SELECTOR SWITCHING VALVE KIT 3 PORT FV1T FV1 Switch Auxiliary

Description: PART # FV1-KIT 【 STANDARD MOTOR PRODUCT 】 W/ 10 Feet of connector wire, Connector , Clamps, Fuse Holder, Fuse. Kit【 PREMIUM KIT 】W/ Complete instructions fuse color/amp vary【 INSTRUCTIONS 】NOTE: Not for systems using in-tank fuel pumps or pumps located between the tanks and valve. Not for Marine use.【 FUSE KIT, WIRING, CONNECTORS 】 SMP as in Picture【 STANDARD MOTOR PRODUCT 】NOTE: Not for systems using in-tank fuel pumps or pumps located between the tanks and valve. Not for Marine use.› See more product details STANDARD MOTOR PRODUCT. New in box! FUEL TANK SELECTOR VALVE GAS OR DIESEL 3 PORT FOR MAIN TANK AUXILIARY TANK . Intended for use with the following: Vehicles with one main and one auxiliary fuel tank. Vehicles without fuel return lines. 12 Volt systems. Can be used for either gasoline or diesel fuels. Located between the Fuel Pump and the Fuel Tank* *** 3/8" Hose Barbs for use with 5/16" fuel lines. Not for systems using in-tank fuel pumps or pumps located between the tanks and valve. Note: Fuel injections systems and diesel systems commonly have in-tank pressure pumps. Vacuum not to exceed 8 PSI. Not for marine applications INSTALLATION INSTRUCTIONSThis Selector Valve is intended for use with the following: • Vehicles with one main and one auxiliary fuel tank. • Vehicles without fuel return lines. • 12 Volt systems. • Ambient temperatures between -40°F and +180°F. The selector valve must be located between the Fuel Pump and the Fuel Tanks. Not for systems using intank fuel pumps or pumps located between the tanks and valve. Note: Fuel injection systems and diesel fuel systems commonly have intank pressure pumps. • Vacuum not to exceed 8 P.S.I. • Not for marine applications. II. INSTALLATION INSTRUCTIONS Selector valve should be installed as shown above. Choose a protected location near the original fuel line and mount the selector valve to a chassis rail (horizontal valve position preferred). Bolt valve mounting bracket to chassis using external tooth lockwashers for good ground. Route the auxiliary tank fuel line to the selector valve as shown. Cut the original fuel line. Using properly tightened clamps and 5/16” fuel approved flexible hose, connect the fuel lines to the selector valve as shown. Fuel line routing should minimize bends and have largest possible radius for better flow. A fuel filter must be installed between each fuel tank and the selector valve input ports to prevent foreign matter from entering the valve and causing it to malfunction. After assembly, check the system for leaks. Choose a position on the dash to mount the toggle selector switch. Cut the original wire from the sending unit to the fuel gauge and connect it to the selector switch as shown. Connect a new wire from the switch to the auxiliary tank sending unit and another new wire to the selector valve. The connection to the selector valve should be made by placing the properly stripped wire between the two washers and wrapping it twice in a clockwise direction around the terminal. The nut should be securely tightened and a coating of grease applied to prevent corrosion. Connect a new wire from the “accessory” power to the selector toggle switch through a 1 amp fuse. Indicator plate should be used for proper indication of tank selected. It is normal for “Constant Duty” solenoids to run warm. FUEL FLOW: Valve de-energized: flow is from the main fuel tank thru the valve to the fuel pump. Valve energized: flow is from the auxiliary tank thru the valve to the fuel pump.

Price: 52.15 USD

Location: Laguna Hills, California

End Time: 2023-12-16T07:37:10.000Z

Shipping Cost: 0 USD